Afrindustria/ Gas Gap Monitor

Library / GUIDE FOR THE ESTABLISHMENT AND OPERATIONS OF DOWNSTREAM GAS FACILITIES IN NIGERIA (LPG, CNG, LNG) ISSUED BY

GUIDE FOR THE ESTABLISHMENT AND OPERATIONS OF DOWNSTREAM GAS FACILITIES IN NIGERIA (LPG, CNG, LNG) ISSUED BY

Page 34 of 194

Open the PDF at page 34

 
 
 
 
Applicable to all Oil & Gas Operators  
GUIDELINES FOR THE STANDARD OPERATIONS OF LPG REFILLING 
FACILITY IN NIGERIA  
Code: DPR Guide 0043 - 2020 
 
Revision Date: 1st September 2020 
 
 
 
This is a property of the Department of Petroleum Resources. All rights reserved  
 
1 
1. INTRODUCTION  
1.1 
Purpose  
This guideline is issued pursuant to the Petroleum Act, 1969, Mineral Oils (Safety) 
Regulations, 1997 and Part IV, Section 87 (2) of the Petroleum Regulations, 1967. This 
document stipulates the minimum requirement and procedures for the development of 
Standard Operating Procedure (SOP) for Operations in a Liquefied Petroleum Gas Refilling 
Plant in Nigeria. The objective is to ensure that the base line standard regarding HSE is 
achieved and maintained in all LPG Refilling Facility in Nigeria. 
1.2 
Scope  
These guidelines apply to all operations in an LPG Refilling plant including; vehicular 
movements, road tanker off-loading, product transfers, gas cylinder refilling, pump house 
and related safety provisions. 
   
2. GENERAL PROVISIONS  
The general requirements are, at a minimum, the following: 
i. 
No persons shall construct, modify, install and operate an LPG handling plant 
without an approval/ licence for such operations as provided in the ‘Guidelines for 
the Establishment of LPG Refilling Facilities and Retailers’ Outlets in Nigeria’ issued 
by the Department. 
ii. 
 All LPG refilling plants shall possess valid DPR licences at all times.  
iii. 
All LPG refilling plants shall develop a detailed Standard Operating Procedure 
(SOP), which must be approved by the DPR in line with the provisions of these 
guidelines. The Standard Operating Procedures shall contain operating instructions 
for the safe, continuing and reliable operations of all installations in the plant.